There seems to be a bit of PLA in the screw hole of the hotend, probably from a previous clog, and that is preventing me from unscrewing it. Any tips?
Heat up the hot end then unscrew?
“It can’t be stuck if it’s liquid.” -old mechanic
I came here to say that
When in doubt, get hot and screw.
Instructions unclear, penis stuck in hot end.
Your printer has the hidden ability of being able to melt plastic 😉
Thanks, I was just worried that it could damage the hotend if I were to unscrew it while hot.
As long as your thermistor or heater block doesn’t fall out you should be fine. But if you want to be safe, just set it to 200 and then turn it off before you unscrew it so that it won’t thermal runaway if it comes apart while working on it.
Thanks very much.
Lighter + Screwdriver then shove it in.
hotend
What word is this?
Wow. There is a word ‘hotend’.
Is it pronounced ‘ho tend’ or is it pronounced in a way that makes you wonder whether someone forgot a space? (Or a T, I guess)
Hot end. Its the end that gets hot.
